THIS PRODUCT IS IN REVISION. AVAILABILITY UNKNOWN AT THIS TIME.
I-Charge 2 Triple Battery Expandable Charger
This new from Advanced Radio is the solution to charging your Duralite Sentinel batteries! The I-Charger is small enough to be mounted "on-board" or used externally.
The Advanced Radio I-Charge V2 is the world’s smallest intelligent expandable battery charger, capable of charging up to 3 (expandable to 4) batteries simultaneously.
Based on the success of the original I-Charger, the Team at Advanced Radio have managed to capture the ability of a huge quad charger and shrink it down into the smallest, intelligent battery charger on the market.
Capable of charging all current receiver batteries.
I-Charge V2 ECU comes capable of charging all of the latest receiver battery chemistries including 2s li-ion, LiFE, Lipo.
I-Charge is so light weight that you can easily mount it into your model and with a simple 12v car battery connection you can charge all batteries simultaneously.
I-Charger is also easily expandable with the addition of a 4th charge board. Click here
Example: We have several models with 2 x receiver batteries, 1 x ignition battery and an auxillary battery (lights and/or electric retracts) for a total of 4 batteries. No problem, with the I-Charge you can easily add a 4th charge board and charge all 4 batteries simultaneously.
The I-Charge V2 now comes standard as a 3 stack charger capable of charging up to 3 batteries. The entire I-Charge range can now be independently upgraded to include additional stacks. The pocket charger, I-Charge V2 and I-Charge V2 Turbine can be upgraded with an additional stack
Intelligent charging algorithm:
The I-Charge V2 is programmed with a 3 phase charge cycle, Pre-Charge, full charge and trickle charge. Pre-charge will begin as soon as the charger starts a charge, the I-Charger will try and charge the pack to a nominal voltage where it will switch over to full charge. Full charge will pump the pack with up to a 2amps, ensuring a fast charge to get you back in the air fast. Once the pack reaches 90% charger, the I-Charger will move to trickle charge mode and will continue to charge the batteries till the pack reaches 100% capacity.
On screen monitoring
Instantly know the health of your packs. The I-Charge V2 is equipped with an on-board full colour LED screen providing feedback on the voltage, mA and charge rate of each pack while charging. You can sit for hours watching your packs and get direct feedback on each pack every step of the way or check every so often and know the I-Charger is doing its thing.
Built with safety in mind
The I-Charge is built with the utmost safety in mind. With built in on-board thermal protection and charge limiting the I-Charger constantly monitors the temperature of each charger board and will limit charge rate or show a fault if there is an issue. The I-Charge V2 comes equipped with external temperature port for each stack. With the addition of a AR temp probe, you can monitor the heat of your packs during a charge. If the pack raises in temp the I-Charge will show a fault and stop charging. Giving you peace of mind during the entire charge process.
Notes about the IChargers and the additional stacks:
There are 2 models of the I-Charger. The standard model which can charge 3 x 2S batteries and the ECU model which can charge 2 x 2S and 1 x 3S battery. Both I-Chargers can charge both external balance and internal balance batteries.
You can add an additional 2S or 3S stack to either model: